To wirelessly connect the smoke detectors, follow these steps:
Register the main unit:
- Press and hold the test/hush/network button on one smoke detector until the LED starts flashing.
- This device is now the main unit and is ready to pair with other detectors.
Pair additional smoke detectors (subunits):
- Press and briefly hold the test/hush/network button on a second smoke detector.
- The LED on this detector will light up briefly and then start flashing to indicate that the pairing was successful.
- Repeat this step for all additional smoke detectors.
Confirm the pairing:
- After a few seconds, the flashing will stop, indicating that the pairing process is complete.
- You can perform a test by pressing the test button on any of the paired detectors. All paired detectors should now emit an alarm signal.
How do I check if the pairing was successful?
- Press the test button on any smoke detector.
- If the pairing was completed correctly, all paired smoke detectors will sound the alarm simultaneously.